EMT Practice Test

1. Question Content...

---

Question1: After adding new nodes to an HCP G10 system, which two actions should be performed? (Choose two.)

Question2: How should the RAID group(s) and logical volume(s) be configured on an HCP G10 node with six internal drives?

Question3: Which two statements are true about the HCP G10 SSD option? (Choose two.)

Question4: Your customer has tested a new HCP G10 with an S10 node and they now want to re-install the S10 node before turning it into production.
What are three requirements? (Choose three.)

Question5: What is the Base Configuration of the Compute Storage (CS) tray on an HCP S11?

Question6: What is required to configure host group security on a new HCP G10 with attached storage?

Question7: What is the default password to log into the HCP G10 node BIOS?

Question8: When do you need to check the BIOS configuration on an HCP G10 node?

Question9: Your customer wants to order an HCP G10 system with 2 PB usable capacity.
Which HCP G10 configuration is the most cost-effective solution for this customer?

Question10: What does the HCP Data Protection Level setting identify?

Question11: What is a requirement for a running HCP system to maintain quorum for cluster operations?

Question12: In the event of a SAN-attached G10 node failure, which LUN configuration will maintain access to a given set of data LUNs?

Question13: What are two supported speed combinations for the Front-End and Back-End networks of an HCP G11? (Choose two.)

Question14: You are preparing to perform an offline upgrade on an HCP G10 and the pre-upgrade check procedure fails. The error message says that you do not have enough capacity on node 103 to perform the upgrade.
Which service procedure should you run to resolve this problem?

Question15: You are performing a six-drive upgrade of an HCP G10 with local storage.
Which two statements are true? (Choose two.)

Question16: Which two VMware deployment packages are supported by HCP systems running v7.2 or later? (Choose two.)